Nortel Networks 9150 - Manual (Page 404)

374 Remote Gateway 9150 Installation and Administration Guide
Planning forms Standard 3.1
Completing the Remote Gateway 9150 forms
This section briefly describes how to complete the Remote Gateway 9150
configuration forms.
To complete the forms:
1 Assign each user telephone or fax machine to a port on the Remote
Gateway 9150 unit.
Record the assignments on the Remote Gateway 9150 Configuration
Information—Stations form. Designate each port as a local port, remote
port, or local and remote port.
2 Use the information you received from the ISDN service provider for the
Remote Gateway 9150 site to complete the Remote Gateway 9150
Configuration Information—ISDN BRI Modules form.
At the same time, do the following:
a. Designate a B-channel as a primary trunk. The Remote Gateway 9150
unit uses primary trunk to establish connections between the Remote
Gateway 9150 unit and the RLC.
Note: The primary trunk on the Remote Gateway 9150 unit is defined
as follows:
!
the lowest-numbered B-channel defined as Remote only
!
the lowest-numbered B-channel defined as Local and Remote
Do not include the primary trunk in any trunk groups. Nortel
recommends that you define the primary trunk as Remote only.
Record the primary trunk assignment in the “Connection to RLC
information” section on the Remote Gateway 9150 Configuration
Information—Network Connections form.
b. Assign B-channels to trunk groups. Record the assignments on the
ISDN BRI Modules form.