Tm 3.1 pc hardware and software requirements, Hard drive requirements – Nortel Networks NN43001-563 User Manual

Page 175

Advertising
background image

TM 3.1 PC hardware and software requirements

175

integrity is highly valued, a Redundant Array of Inexpensive Disks (RAID)
storage solution is recommended. Tape or other backup methods are highly
recommended.

When installing TM 3.1 client applications, it is important for the network
drive to be mapped the same from each PC if an TM 3.1 user is expected
to be able to login to the network with their network login ID at any TM
3.1 client PC.

A PC security device is required for every PC running TM 3.1. A security
device is not required for the PC server as it is only used to store TM 3.1
data and does not actually run any TM 3.1 applications.

Each of the TM 3.1 client PCs on the customer LAN is allowed connectivity
to the IP addresses of the Meridian 1s. Nortel recommends the following:

1. TM 3.1 client PC in switchroom has access to the File Server on the

customer network.

2. Block broadcast messages from the customer LAN to the system private

LAN.

3. Block access to the system private LAN from non-TM 3.1 client PCs

for security reasons.

TM 3.1 PC hardware and software requirements

The following list provides the recommended minimum PC hardware and
software recommended to run TM 3.1. Other applications launched while
using TM 3.1 can require increased RAM. The minimum requirements are
as follows:

an Intel Pentium II Processor 400 MHz CPU minimum; Intel Pentium III
Processor 600 MHz CPU recommended

2 GB or larger hard disk drive with 1000 MB or more free space. Refer
to the system datastore column in the hard drive requirements in

Table

36 "Hard drive capacity for OTM 2.1 (and later) applications" (page 176)

.

256 MB of RAM (minimum); 512 MB recommended

SVGA color monitor and interface card (800x600 resolution for graphics)

CD-ROM drive and 3.5 in 1.44 MB floppy disk drive

two Ethernet Network Interface Cards

Hayes-compatible modem is optional to connect to remote systems,
required for polling configurations (56 Kbps recommended)

PC COM port with 16550 UART

printer port (required for the dongle)

dongle (for server or stand-alone only)

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007

Copyright © 2007, Nortel Networks

.

Advertising