Nortel Networks NN43001-563 - Manual (Page 373)

Access the ITG shell through a maintenance port or Telnet 373
At the ITG shell prompt, type:
resetOM
Display the number of DSPs
At the ITG shell prompt, type the following command to display the number
of DSPs on the IP trunk card:
DSPNumShow
Display IP Trunk 3.01 (and later) node Properties
At the ITG shell prompt, type the following command to display information
about an IP Trunk 3.01 (and later) node:
IPInfoShow
The following IP Trunk 3.01 (and later) node information appears on the TTY:
• IP addresses for the ELAN and TLAN network interfaces
• default router for the ELAN and TLAN network interfaces
• subnet mask for the ELAN and TLAN network interfaces
• SNMP manager
At the ITG shell prompt, type the following command to display information
about an IP trunk card:
itgCardShow
The command itgCardShow prints out the information that was
provisioned in TM 3.1, such as the IP trunk card TN, protocol used, card
role, IP addresses, and whether the DCH PC Card is on board. If the IP
trunk card is enabled, the status of the IP trunk card (Card Mode) and the
D-channel (DCH Status) is also displayed.
The following is an example of the itgCardShow command:
Index: 1
Type: ITG2
Role: Leader
Leader IP: 47.11.215.182
RTP Base Port: 2300,2300=>Default 173300+>Cisco
RTPHeaderCpmpresssion
Card IP: 47.11.215.186
Card MgtIP: 47.11.217.21
Ldr MgtIP: 47.11.217.21
Card TN: 9 0 0
Card State: ENBL
Card Mode: Normal
Codecs: G.711 mu-law (default), G.711 a-law, G.729AB,
G.729A
EC Tail Length: Value from TM 3.1-32
DCHIP IP: 47.11.217.21
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.