Before configuration data is transmitted, Configure the leader 0 ip address, Procedure 27 configure the leader 0 ip address – Nortel Networks NN43001-563 User Manual

Page 259

Advertising
background image

Transmit IP trunk card configuration data from TM 3.1 to the IP trunk cards

259

Transmit IP trunk card configuration data from TM 3.1 to the IP
trunk cards

IP Trunk 3.01 (and later) nodes and IP trunk cards are configured in the
TM 3.1 ITG ISDN IP Trunk application and then transmitted to the IP trunk
cards. The configuration data is converted by TM 3.1 to text files. The IP
trunk cards then obtain the configuration files from TM 3.1 using an FTP
server on TM 3.1.

ATTENTION

Important

When TM 3.1 is launched, it launches its own FTP service. Other FTP services,
such as those found in Windows NT4 and Windows 2000 (which are launched by
default) must be turned off, or TM 3.1 will not work properly.

Before configuration data is transmitted

Perform the following procedures in any order before transmitting
configuration data:

Install the IP trunk cards in the system IPE modules or cabinets and
cable them to the TLAN and ELAN Ethernet hubs, Ethernet Layer
2/Layer 3 switches, and IP routers.

Configure the IP Trunk 3.01 (and later) data in the system. Disable the
IP trunk cards in LD 32.

Configure the IP Trunk 3.01 (and later) data in TM 3.1.

Connect a local RS-232 terminal to the serial maintenance port to
configure the Leader 0 IP address. Under certain conditions, the local
terminal is required to configure IP routing table entries in the Leader 1
IP trunk card and each of the Follower cards.

Connect the TM 3.1 PC to the local ELAN subnet or to a remote subnet
across the LAN/WAN from a remote subnet.

Configure the Leader 0 IP address

Follow the steps in

Procedure 27 "Configure the Leader 0 IP address" (page

259)

to configure the IP address of the Leader 0 IP trunk card, using the

ITG shell Command Line Interface (CLI).

Procedure 27

Configure the Leader 0 IP address

Step

Action

1

To access the ITG shell, connect an TM 3.1 PC to the RS-232 serial
maintenance port on the faceplate of the Leader 0 IP trunk card
through an NTAG81CA PC Maintenance cable. If required, use an

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007

Copyright © 2007, Nortel Networks

.

Advertising