Nortel Networks NN43001-563 - Manual (Page 83)

SNMP MIB 83
• TCP
• UDP
• SNMP
The WindNet agent supports both SNMP-V1 and V2c protocols.
IP Trunk 3.01 (and later) SNMP agent
The SNMP agent supports the Operation, Administration, and Maintenance
(OA&M) of IP Trunk 3.01 (and later), using TM 3.1. It can configure the IP
trunk card through file transfer services. The agent supports the SNMP-V1
protocol.
The SNMP agent provides the following capabilities:
• Retrieval of system wide variables, such as:
— card state
— number of DSPs on the card
— number of available voice channels
— IP addresses
— software version
— number of IP Trunk 3.01 (and later) nodes in fallback (that is, PSTN
operation)
• Control of D-channel state, such as:
— enable
— disable
— release
— establish
• Retrieval of DSP information, such as:
— DSP firmware
— DSP self-test status
— card reset
• SNMP configuration (that is, community names and trap subscription)
— alarm generation through SNMP traps
• File transfer, including configuration files, software upgrade, dialing plan
files, bootp files, activity log, and call trace files
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.