Nortel Networks NN43001-563 - Manual (Page 372)

372 OA and M using the ITG shell CLI and overlays
VxWorks login: itgadmin
Password: itgadmin
ITG>
6 If this card is Leader 0, use the setLeader command:
ITG> setLeader xxx.xxx.xxx.xxx, yyy.yyy.yyy.yyy,
zzz.zzz.zzz.zzz and press Enter.
where
• xxx.xxx.xxx.xxx is the IP address of the ELAN network interface
on Leader 0.
• yyy.yyy.yyy.yyy is the gateway IP address for the ELAN network
interface on Leader 0. If the TM 3.1 PC is connected directly to
the LAN and there is no ELAN network interface gateway, then
the gateway IP address is "0.0.0.0".
• zzz.zzz.zzz.zzz is the subnet mask for the ELAN network
interface on Leader 0.
7 Do not leave the card with the default user name and password.
"Change the default ITG shell password to maintain access security"
(page 369)
8 Configure all the IP trunk cards in the same node with the same
password. Repeat this procedure for other cards in the IP Trunk
3.01 (and later) node.
—End—
Download the ITG operational measurements through the ITG shell
The ITG operational measurements file contains counts of incoming and
outgoing calls, call attempts, calls completed, and total holding time for
voice and fax calls. To download this file from the TM 3.1 PC to the IP trunk
card, at the ITG shell prompt, type the following:
currOMFilePut <hostname, username, password, directory path,
filename> for the current file
or
prevOMFilePut <hostname, username, password, directory path,
filename> for the previous file.
Reset the operational measurements
This command resets all operational measurement (OM) parameters
collected after the last log dump.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.