Nortel Networks NN43001-563 - Manual (Page 251)

Control node access with SNMP community name strings 251
Figure 58
ITG Node Properties Security Tab
Change the current System Mgmt Read and System Mgmt Read/Write
community name strings as per the Card. TM 3.1 uses the previous
read/write community name to transmit the card properties. The first time
data is transmitted after changing the password, TM 3.1 uses the previous
read/write password. TM 3.1 uses the changed password for all following
data transmissions.
For more information on SNMP, refer to Communication Server 1000 Fault
Management - SNMP (NN43001-719).
Exit node property configuration session
The procedure to add an IP Trunk 3.01 (and later) node manually in TM 3.1
is complete. Click OK to save the node and card properties configuration
and exit. TM 3.1 displays the IP Telephony Gateway - ISDN IP Trunk
window. If a network of IP Trunk 3.01 (and later) nodes is to be managed
from this TM 3.1 PC, add the remaining IP Trunk 3.01 (and later) nodes
before configuring the dialing plan for the new IP Trunk 3.01 (and later)
nodes on TM 3.1.
Create the IP Trunk 3.01 (and later) node dialing plan using TM 3.1
Follow the steps in Procedure 24 "Configure the ITG Dialing Plan – General
tab" (page 252) to configure the IP Trunk 3.01 (and later) node dialing plan
in TM 3.1. Use this procedure to create the dialing plan for the first node in
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.