Nortel Networks NN43001-563 - Manual (Page 273)

Check and download IP trunk card software in TM 3.1 273
• For ITG-Pentium 24-port trunk cards, download the Software
Package for Release IP Trunk 3.01 (and later).
8 When prompted, select Download. Record the file name and
location of downloaded software on the TM 3.1 PC.
—End—
Now the new IP trunk card software is ready to be transmitted from TM 3.1
to the IP trunk cards.
Transmit new software to the IP trunk cards
Verify that the IP trunk cards are disabled before transmitting new card
software.
Disable the IP trunk cards when transmitting card properties or new
software.
Use the TM 3.1 Maintenance Windows, the TM 3.1 System Passthru
terminal, or a system management terminal directly connected to a TTY
port on the system.
Use the LD 32 DISI command to disable the IP trunk cards when idle.
NPROG indicates that all units on the card have been disabled.
In the TM 3.1 IP Telephony Gateway - ISDN IP Trunk window, select View
> Refresh and verify that the card status is showing "Disabled". If the card
status shows "unequipped", configure the card in LD 14.
Follow the steps in Procedure 36 "Transmitting new software to the IP trunk
cards" (page 273) to transmit the new software to the IP trunk cards.
Procedure 36
Transmitting new software to the IP trunk cards
Step Action
1 Open TM 3.1. Click Services and launch the ITG ISDN IP Trunks
application.
2 Select the node to upgrade from the list in the upper half of the IP
Telephony Gateway - ISDN IP Trunk window.
3 Select node or cards for software transmission according to card
density:
• If all cards in the node have same card density (24-port or
32-port), upgrade all the cards together by transmitting to the
selected node. Click the new node in the upper half of the IP
Telephony Gateway - ISDN IP Trunk window.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.