Nortel Networks NN43001-563 - Manual (Page 240)

240 Install and configure IP Trunk 3.01 (and later) node
Figure 52
Configuration tab
The TLAN Node IP address on the General tab and the TLAN
network interface IP address and TLAN network interface gateway
IP addresses for Leader 0 and Leader 1 on the Card Configuration
tab must be on the same TLAN subnet.
Each Follower card can optionally have its TLAN network interface
IP address and TLAN network interface gateway IP address on a
different TLAN subnet than Leader 0 and Leader 1.
4 If Use separate subnets in the General tab was unchecked earlier,
perform steps a and b:
a. Enter the Management IP address (ELAN network interface IP
address).
b. Enter the Management MAC address ELAN network interface
MAC address). It is the motherboard Ethernet address. Find
it on the faceplate label of the IP trunk card currently being
configured. It is also identified as lnIsa0 on the card startup
messages and by the
ifShow command in the ITG shell.
The TLAN Node IP and ELAN network interface gateway IP
addresses on the General tab and the ELAN network interface
IP address for Leader 0, Leader 1 and all Follower cards on the
Card Configuration tab must be on the same ELAN subnet.
5 Enter the Card TN. For Large Systems, the card TNs are validated
for loop, shelf and card separated by dashes. For Small Systems,
only the card number is required.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.