Nortel Networks NN43001-563 - Manual (Page 360)

360 TM 3.1 OA and M using TM 3.1 applications
For more information about Alarm Notification, please refer to Alarm
Management in Telephony Manager 3.1 System Administration
(NN43050-601).
System commands LD 32
The following system administration commands can be performed in LD 32:
• "Disable the indicated IP trunk card" (page 361) .
The IP trunk card must be disabled before card properties can be
transmitted from the TM 3.1 IP Trunk 3.01 (and later) application to the
IP trunk card.
The IP trunk card reset button is only available in the TM 3.1 IP Trunk
3.01 (and later) application when the IP trunk card is disabled.
Disabling the IP trunk card in LD 32 does not disable the Active Leader,
Backup Leader, or DCHIP functions.
• "Disable the indicated IP trunk card when idle" (page 362) .
This temporarily prevents the IP Trunk 3.01 (and later) node from seizing
the port from incoming calls.
• "Disable an indicated IP trunk card port" (page 362) .
• "Enable an indicated IP trunk card" (page 362) .
• "Enable an indicated IP trunk card port" (page 362) .
• "Display IP trunk card ID information" (page 362) .
This command displays the PEC (Product Engineering Code) for the
card. The ITG PEC is as follows:
ITG 8-port trunk card – NT0961AA
ITG-Pentium 24-port trunk card – NT0966AA
Media Card 32-port trunk card – NT0966BA
The IP trunk card information displays the same IP trunk card serial
number that is displayed from the ITG shell using the
serialNumShow .
• "Display IP trunk card status" (page 362) .
• "Display IP trunk card port status" (page 363) .
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.