Nortel Networks NN43001-563 - Manual (Page 404)

404 Maintenance
Command Description
NVRIPShow Print the values of the IP parameters that exist in NVRAM.
Example: ITG> NVRIPShow
nvramLeaderSet Set the leader bit in NVRAM.
Example: ITG> nvramLeaderSet
nvramLeaderClr Clear the leader bit in NVRAM, but does not erase the IP
parameters in NVRAM.
Example: ITG> nvramLeaderClr
NVRClear Clear IP parameters in NVRAM.
Example: ITG> NVRClear
setLeader IP address, IP
gateway, subnet mask
The one command that does all the necessary actions to
make a Leader. Sets IP address, gateway, subnet mask, boot
method to static, and Leader bit in NVRAM.
Example: ITG> setLeader "47.23.45.67", "47.0.0.1", "255.255.240.0"
clearLeader The one command that does all the necessary actions to clear
the Leader information in NVRAM and set the boot method to
use BOOTP, thus, making the card a Follower.
Example: ITG> clearLeader
Table 64
DSP commands
Command Description
DSPReset DSP Number Reset the indicated DSP.
Example: ITG>DSPReset 0
DSPSelfTest DSP Number Run self-test on the DSP.
Example: ITG>DSPSelfTest 0
DSPNumShow Print number of DSPs on IP trunk card.
Example: ITG>DSPNumShow
DSPPcmLpbkTestOn Start PCM loopback test on the indicated DSP.
Example: ITG>DSPPcmLpbkTestOn
DSPPcmLpbkTestOff Stop PCM loopback test on the indicated DSP.
Example: ITG> DSPPcmLpbkTestOff
DSPSndLpbkTestOn Start Send loopback test on the indicated DSP.
Example: ITG> DSPSndLpbkTestOn
DSPSndLpbkTestOff Stop Send loopback test on the indicated DSP.
Example: ITG> DSPSndLpbkTestOff
DSPRcvLpbkTestOn Start Receive loopback test on the indicated DSP.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.