Nortel Networks NN43001-563 - Manual (Page 480)

480 Appendix G Upgrade an ITG Trunk 1.0 node to support ISDN signaling trunks
Figure 157
Software download example
9 To verify the software upgrade on Leader 0, telnet to the IP address
of the Leader 0 card. Leader 0 is the only card that has an IP
address configured at this stage of the upgrade. Enter the following
command:
ITG> swVersionShow
10 Configure the ITG Trunk 2.0 data on the TM 3.1 ITG ISDN IP Trunk
application.
"Configure IP Trunk 3.01 (and later) data in OTM 2.1
(and later)" (page 234)
11 Transmit configuration data to the upgraded ITG 8-port trunk cards
using normal ITG Trunk 2.0 installation procedures.
12 Upgrade Meridian 1 to Release 25 software.
—End—
Remove ITG Trunk 1.0 configuration data from Meridian 1
Follow the steps in Procedure 84 "Removing the ITG Trunk 1.0 configuration
data from Meridian 1" (page 481) to remove the ITG Trunk 1.0 configuration
data from Meridian 1.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.