Nortel Networks NN43001-563 - Manual (Page 374)

374 OA and M using the ITG shell CLI and overlays
DCH Num: 10
DCH ON Card: YES (version 3.1)
DCH Status: ENBL
Protocol: SL1 ESN5
initBchNum: 1
esn5Prefix: |100|
TLAN set to Auto-negotiate Speed and Duplex Settings
TLAN currrently operate at: 100 Mbps (Carrier OK)
ELAN set to 10BaseT Operation
ELAN set to Half Duplex Operation
value = 38 = 0x26 = ’&’
The following commands give additional information about an IP trunk card:
• ldrResTableShow
• ifShow
• dongleIDShow
• serialNumShow
• firmwareVersionShow
• swVersionShow
• emodelSim
Display IP Trunk 3.01 (and later) Gatekeeper status
At the ITG shell prompt, type the following command to display information
about the IP Trunk 3.01 (and later) registration with a Gatekeeper:
gkShow
The following information appears on the TTY:
• provisioned information (for example, the H.323 node name, which card
to register, and the Gatekeeper IP address)
• operational information, such as whether the IP trunk card is registered
with the Gatekeeper and with which Gatekeeper the IP trunk card is
registered (Primary or Alternate)
• when the next re-registration attempt will occur
• values from the Gatekeeper, such as Time To Live (TTL) and endpoint ID
The time to re-register is based on the clock on the Leader 0 IP trunk
card. If the clocks on the Leader 1 and Follower IP trunk cards are out of
synchronization with the Leader 0 clock, the time to re-register might be
incorrect. The time that the next re-register will occur is always correct on
the Leader 0 IP trunk card.
The following is an example of the output of the gkshow command when
there is only a Primary Gatekeeper.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.