Nortel Networks NN43001-563 - Manual (Page 265)

Transmit IP trunk card configuration data from TM 3.1 to the IP trunk cards 265
Verify installation and configuration
To verify installation and configuration, check the IP trunk card faceplate
displays.
After successfully rebooting, the Leader 0 card is now fully configured with
the Node Properties of the node and enters a state of "Active Leader". The
faceplate display shows "LDR".
The Leader 1 card is now autoconfigured as a Leader, reboots automatically,
and enters the state of "Backup Leader". The faceplate display shows
"BLDR".
Any Follower cards are now auto-configured with their IP addresses and
their display shows "FLR".
If an TM 3.1 PC is on the local ELAN subnet, it should now be in
communication with all cards in the IP Trunk 3.01 (and later) node.
Observe IP Trunk 3.01 (and later) status in TM 3.1
Follow the steps in Procedure 30 "Observing the IP Trunk 3.01 (and later)
status in OTM 2.1 (and later)" (page 265) to observe the IP Trunk 3.01
(and later) status in TM 3.1.
Procedure 30
Observing the IP Trunk 3.01 (and later) status in TM 3.1
Step Action
1 From the TM 3.1 IP Telephony Gateway - ISDN IP Trunk window,
select menu View > Refresh and verify that the card status is
showing "enabled" or "disabled", depending on the card status in the
system. See
Figure 61 "IP trunk card status" (page 266) . If any
cards show "not responding", verify the following:
a. the ELAN network interface cable connection to the ELAN subnet
b. the TLAN network interface cable connection to the TLAN subnet
c. the ELAN MAC addresses that were entered previously on the
Configuration tab of the Node Properties, while adding the IP
Trunk 3.01 (and later) node on TM 3.1
d. IP addresses
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.