Nortel Networks NN43001-563 - Manual (Page 415)

Replace an IP trunk card 415
3 If the card to be replaced is an ITG 8-port trunk card, disconnect the
TLAN Ethernet cable from the faceplate of the bad card. Label the
cable to identify it as the TLAN Ethernet connection so it can later be
reattached to the replacement card.
If the card to be replaced is an ITG 8-port trunk card or a
ITG-Pentium 24-port trunk card, disconnect the TLAN Ethernet cable
from the I/O cable. Label the cable to identify it as the TLAN Ethernet
connection to aid in re-installing the cable on the replacement card.
Remove the defective IP trunk card.
If the card to be replaced is an Media Card 32-port trunk card,
disconnect the TLAN Ethernet cable from the I/O cable or L-adapter.
Label the cable to identify it as the TLAN Ethernet connection to
aid in re-installing the cable on the replacement card. Remove the
defective Media Card 32-port trunk card from the system.
4 From the lower window, select Leader 0 or any IP trunk card in the
node.
5 Select menu Configuration > Node > Properties in the IP
Telephony Gateway window.
6 Click the Configuration tab in the ITG Node Properties window.
7 In the Configuration tab, select the defective IP trunk card from the
list of cards in the node.
8 Change the MAC address to the MAC address of the replacement IP
trunk card. The MAC address is the "Motherboard Ethernet" address
on the faceplate label of the replacement IP trunk card.
9 Click "OK".
10 Select Leader 0 or any IP trunk card in the node.
11 Select menu Configuration > Synchronize > Transmit to transmit
the Node Properties from TM 3.1 to the Active Leader card of the
IP Trunk 3.01 (and later) node. Click the "Node Properties" box and
then click "Start Transmit." This updates the node properties of the
Active Leader card with the MAC address of the replacement IP
trunk card.
12 Install the replacement IP trunk card into the system:
a. Pull the top and bottom locking devices away from the IP trunk
card faceplate.
b. Insert the IP trunk card into the card guides and carefully push it
until it makes contact with the backplane connector. Hook the
locking devices.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.