Nortel Networks NN43001-563 - Manual (Page 225)

Configure IP Trunk 3.01 (and later) data 225
M911P (NO)/YES M911 trunk type for MCDN network.
M911_ABAN (NO)/YES Optional call abandon treatment:
YES = abandoned call treatment for route.
NO = no abandoned call treatment for route.
M911_TONE YES/(NO) YES = tone given on answer.
NO= silence given on answer.
ABTR (15) Range 0-30 Timer (in minutes) blocks the disconnect from being
tandemed across to the target node. Default value: 15
minutes. This timer value can be added in increments
of 1 minute.
VTRK (NO)YES YES = supports IP Peer facilities.
NODE <Node ID> Node ID associated with the Signalling Server dedicated
for 911P trunks.
IFC SL1 IFC is set to SL1 by default if M911P is set to YES. This
prompt is not configurable.
If the DTI and PRI2 packages are restricted and the VTRK prompt is set
to NO, SCH2160 is printed on the TTY and VTRK is reprompted. Only
PRI/PRI2 is supported for 911P routes, and if DTI and PRI2 packages are
restricted, VTRK should not be set to NO.
Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and
units for IP Trunk Route
Use LD 14 to configure the Media Card 32-port and ITG-Pentium 24-port
trunk cards and units. Record the first CHID for each IP trunk card on the IP
Trunk 3.01 (and later) Installation Summary Sheet.
LD 14 Configure Media Card 32-port and ITG-Pentium 24-port trunk cards and units
Prompt Response Description
req NEW/CHG/OUT
REQ NEW XX Add new data, where:
xx = 1 – 24 for ITG-Pentium 24-port trunk card
xx = 1 – 32 for Media Card 32-port trunk card
When using REQ = NEW XX, configure only one IP trunk
card at a time.
When using REQ = NEW XX, CHID is incremented for
each of the new units created.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.