Nortel Networks NN43001-563 - Manual (Page 462)

462 Appendix F Configure a Netgear RM356 modem router for remote access
Follow the steps in Procedure 78 "Configure the RM356 modem router
through the manager menu" (page 462) to configure the RM356 modem
router through the manager menu.
Procedure 78
Configure the RM356 modem router through the manager menu
Step Action
1 Press the Enter key.
The ’Enter Password:’ prompt is displayed for 10 seconds.
2 Enter the default RM356 manager password: 1234
The "RM356 Main Menu" appears.
3 Enter menu selection number 1 to access "General Setup" under the
"Getting Started" section of the "RM356 Main Menu."
"Menu 1 – General Setup" is displayed.
4 Type in the system name (19 characters, no spaces), location, and
contact person’s name for the system site. Use the up and down
arrow keys to move the cursor to the prompt "Press ENTER to
Confirm or ESC to Cancel:" at the bottom of the menu. Press Enter
to confirm and save data to ROM.
5 Enter menu selection number 2 under the "Getting Started" section.
"Menu 2 – Modem" is displayed.
6 Type in modem name. Set "Actives". Use arrow keys to navigate
and space bar to toggle values. Set "Direction=Incoming". Type in
the modem router’s telephone number for reference. Press Enter to
confirm and save data to ROM.
7 Enter menu selection number 3, "Ethernet Setup", under the "Getting
started" section.
"Menu 3 – Ethernet Setup" sub-menu is displayed.
8 Enter menu selection 2, "TCP/IP and DHCP Setup".
"Menu 3.2 – TCP/IP and DHCP Ethernet Setup" is displayed.
9 Use the space bar to toggle "DHCP=None".
10 Under "TCP/IP Setup", type in the IP address and the IP subnet
mask for the modem router’s ELAN network interface.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.