Cards – Nortel Networks NN43001-563 User Manual
Page 276
276
Install and configure IP Trunk 3.01 (and later) node
VxWorks login:
itgadmin
Password:
itgadmin
ITG>
4
Disable the ITG-Pentium 24-port or Media Card 32-port trunk card in
LD 32 (DISI lsc). Wait for the NPRxx message.
5
Use the command
DCHdisable
to disable the D-channel function
on the card.
6
Use the command
loader 1, "/C:pcmv32.bin"
to transfer the
DCHIP PC Card software to the DCHIP PC Card.
The ’1’ indicates the internal PC Card slot on the DCHIP Card. For
the external PC Card Slot, use ’0’.
The DCHIP card checks whether or not it is a Leader card.
•
The DCHIP PC Card software is downloaded to the Leader card
first.
If it is a Leader card, it copies the DCHIP PC Card software from its
own /C: drive. If it is not a Leader card, it FTPs the DCHIP PC Card
from the Active Leader card. Since the FTP server on the IP trunk
card is password protected, enter the login and password when
prompted. If correct, the upgrade of the DCHIP PC Card begins.
—End—
Once the upgrade is complete, the DCHIP card reboots automatically.
Configure TM 3.1 Alarm Management to receive SNMP traps from
the IP trunk cards
Follow the steps in
Procedure 38 "Configuring OTM ALarm Management to
receive SNMP traps from the IP trunk cards" (page 277)
to configure TM
3.1 Alarm Management to receive SNMP traps from the IP trunk cards.
The TM 3.1 Alarm Management option must be enabled to perform this
procedure. For the procedure to activate SNMP trap generation on the
IP Trunk 3.01 (and later) node, see
"Configure SNMP Traps/Routing and
. Enter the IP address of the TM 3.1 PC as
described in that procedure.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563
01.01
Standard
Release 5.0
30 May 2007
Copyright © 2007, Nortel Networks
.