Nortel Networks NN43001-563 - Manual (Page 258)

258 Install and configure IP Trunk 3.01 (and later) node
4 Click the Configuration tab. Record the Management IP address of
Leader 0 on the new node.
5 On the Configuration tab, change the Management IP address of
Leader 0 on the new node. Enter the Management IP address of the
Leader 0 card on the existing node recorded in Step 2.
6 Click Change and then click OK.
7 Select the new node in the upper part of the IP Telephony Gateway
- ISDN IP Trunk window.
8 Select menu Configuration > Synchronize > Retrieve to open the
ITG Retrieve Options window.
9 Check only the Dialing Plan check box if the community name for
both the existing and new nodes is the same.
Check the Dialing Plan check box and the Prompt user for
community name check box if the community name for both the
existing and new nodes are different. A dialog box appears. Enter
the new node’s community name.
10 Click Start Retrieve and monitor progress in the Retrieve control
field. Ensure the dialing plan is retrieved successfully and added
to the TM 3.1 database.
11 Click Close to close the ITG Retrieve Options window and return to
the IP Telephony Gateway - ISDN IP Trunk window.
12 Select the new node and double-click to open its Node Properties
sheet.
13 On the Configuration tab, change the Management IP address
of Leader 0 on the new node. Enter the correct Management IP
address of the Leader 0 card on the new node.
14 Click Change and then click OK.
15 Select menu Configuration > Node > Dialing Plan to open the
ITG Dialing Plan window.
16 Inspect the retrieved dialing plan for the new node and make any
necessary modifications. Double-click a dialing plan entry to inspect
its property sheet. To save modifications, click Apply and then OK.
From the View menu, the option is available to view by Digits dialed
or Remote Nodes.
—End—
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.