Transfer files through the command line interface, Transfer – Nortel Networks NN43001-563 User Manual

Page 375

Advertising
background image

Access the ITG shell through a maintenance port or Telnet

375

---------------------------------------

<<PROVISIONED>>

The H.323 ID of this gateway is :

[Shane_IPT_cust0]

First place dialed numbers are resolved:

ATPM

Second place numbers are resolved :

Gatekeeper

Cards that register with the Gatekeeper:

All

<<OPERATIONAL>>

The Current Gatekeeper is :

Primary

The Current Gatekeeper status is :

Registered

<<From the Gatekeeper>>

The Time To Live (TTL) for the node is :

300 seconds

The remaining time to Re-Register is :

276 seconds

The Gateway End Point ID is :

.0.2.6.1.3.1.e.8.2.0.0.3.0.2.0.6.1.4.0.4.0.7.0.0.0.2.b.3.8

.6.2.6.a.7

The Gatekeeper has Pre-Granted ARQ : Not Granted - direct

calls possible

---------------------------------------

Primary Gatekeeper information <<PROVISIONED>>

----------------------------------------

Primary Gatekeeper type is :

CSE1000

Primary Gatekeeper IP information is :

*Gatekeeper IP : 47.11.249.140

*QoS Enabled :

0

*Node Capability :

9 - CSE - Interop Format

---------------------------------------

value = 2 = 0x2

Transfer files through the Command Line Interface

Type one of the following commands at the ITG shell Command Line
Interface (CLI) to enable these actions:

transfer a file from the IP trunk card to an FTP host

transfer a file from an FTP host to the IP trunk card

The correct command depends on the type of file to be transferred.

These commands are from the point of view of the IP trunk card. Commands
with "Get" as part of the command name refer to file transfer from the FTP
host to the IP trunk card. Commands with "Put" as part of the command
name refer to file transfer from the IP trunk card to the FTP host.

For security reasons, there is no generic FTP client on the IP trunk card.
A DIR or PWD (Print Working Directory) command cannot be performed
on the FTP host.

The BOOTP.1 file (transferred by the "

bootPFileGet

" and

"

bootPFilePut

" commands) contains node properties information. The

DPTABLE.1 file (transferred by the "

DPAddrTGet

" and "

DPAddrTPut

"

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563

01.01

Standard

Release 5.0

30 May 2007

Copyright © 2007, Nortel Networks

.

Advertising