Nortel Networks NN43001-563 User Manual
Page 479
Upgrade the ITG 8-port trunk card ITG basic trunk software to ITG/ISL trunk software
479
Transmit Control window open displaying the location of the
software file on TM 3.1.
If the trunk card can be reached by Telnet from TM 3.1, but
TM 3.1 shows the card status as Not Responding, TM 3.1
ITG SNMP MIB is incompatible with the ITG 8-port trunk card
software version. In this case, the software upgrade must be
executed from the ITG shell CLI of each ITG 8-port trunk card
in the node (see step a, and
a. ITG> swDownload "IP address of TM 3.1 PC", "itguser",
"obtuser", " ","ITG28xx.mms" where xx indicates the latest
version of the ITG Trunk 2.0 software for the ITG 8-port trunk
card.
Be sure to hit the space bar after typing in swDownload. Enter the
quotation marks and commas exactly as described in the step a and
as shown in
Figure 157 "Software download example" (page 480)
7
Reset the card. There are three ways to do this:
a. From the IP Telephony Gateway Main window, double-click
each card to open the Card Properties. Click the Reset button if
the trunk card is showing responding. Close the Card Properties
and go to the next card in the list.
b. If the card is showing "Not responding", Telnet to the card and
enter the following command:
ITG> card Reset
c. Press the Reset button on the trunk card faceplate.
The trunk card faceplate shows T.20 in the maintenance display
window.
8
At this point, the trunk cards have ITG 2.0 ISDN functionality and are
in the state of new ITG 8-port trunk cards that need to be configured.
Refer to
"Configure IP Trunk 3.01 (and later) data" (page 216)
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563
01.01
Standard
Release 5.0
30 May 2007
Copyright © 2007, Nortel Networks
.