Nortel Networks NN43001-563 - Manual (Page 383)

System commands LD 32 383
This temporarily prevents the IP Trunk 3.01 (and later) node from seizing
the port from incoming calls.
• "Disable an indicated IP trunk card port" (page 362) .
• "Enable an indicated IP trunk card" (page 362) .
• "Enable an indicated IP trunk card port" (page 362) .
• "Display IP trunk card ID information" (page 362) .
This command displays the PEC (Product Engineering Code) for the card.
The PEC is as follows:
ITG 8-port trunk card – NT0961AA
ITG-Pentium 24-port trunk card – NT0966AA
Media Card 32-port trunk card – NT0966BA
The IP trunk card ID information displays the same IP trunk card serial
number that is displayed from the ITG shell using
serialNumShow .
• "Display IP trunk card status" (page 362) .
• "Display IP trunk card port status" (page 363) .
Table 54 "LD 32 – IP Trunk 3.01 (and later) maintenance commands" (page
383)
shows a summary of the system administration commands available
in LD 32.
Table 54
LD 32 IP Trunk 3.01 (and later) maintenance commands
Command Function
DISC l s c Disable the indicated card, where:
l = loop, s = shelf, c = card
DISI l s c Disable the indicated card when idle, where:
l = loop, s = shelf, c = card
Use the DISI command to disable the IP trunk
card instead of the DISC command. The
disablement of the IP trunk card is indicated by
the NPR011 message.
DISU l s c u Disable the indicated unit, where:
l = loop, s = shelf, c = card, u = unit
ENLC l s c Enable the described IP trunk card, where:
l = loop, s = shelf, c = card
ENLU l s c u Enable the described unit, where:
l = loop, s = shelf, c = card, u = unit
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.