Nortel Networks NN43001-563 - Manual (Page 410)

410 Maintenance
Command Description
pins Puts a patch that has been loaded into memory (using the pload command)
into service. This command activates a patch.
If issued successfully, the pins command indicates that global procedures,
functions, or areas of memory are affected by the patch. The technician is then
prompted and has the choice to proceed or not to proceed.
Syntax:
pins "[handle]"
where [handle] is the number returned by the pload command
If the pins command is issued without a parameter, the technician is prompted
to enter a handle.
poos Deactivates a patch (takes it out-of-service) by restoring the patched procedure
to its original state.
Syntax:
poos "[handle]"
If the poos command is issued without a parameter, the technician is prompted
to enter a handle.
pout Removes a patch from DRAM memory. The patch must be taken out-of-service
(using the poos command) before it can be removed from the system.
Syntax:
pout "[handle]"
If the pout command is issued without a parameter, the technician is prompted
to enter a handle.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.