Nortel Networks NN43001-563 - Manual (Page 250)

250 Install and configure IP Trunk 3.01 (and later) node
2 Click the Enable Radius accounting records checkbox.
3 Enter the Radius accounting server IP address. Add the
same Accounting Server IP address that was configured in the
Card Routing Table entries as discussed in
"Configure SNMP
Traps/Routing and IP addresses tab" (page 246) .
4 Change the default port number from the default (1813), if required.
5 Enter the key. The key is a signature for authentication of the Radius
records. It can be a maximum of 64 alpha-numeric characters.
6 Click Apply.
—End—
Control node access with SNMP community name strings
Change the SNMP community name strings to control access to the IP
Trunk 3.01 (and later) node. TM 3.1 uses the community name strings to
refresh the IP Trunk 3.01 (and later) node and card status and to control the
transmitting and retrieving of files for database synchronization.
To retrieve the community names if forgotten, connect a TTY to the IP trunk
card maintenance port. Restart the IP trunk card. The IP trunk card displays
the community name on the TTY during startup.
The community name strings are configured on the Security tab. These are
not picked up from the System Properties – General tab.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.