Burkert Type 8693 - Manual (Page 122)

122
Start-up and operation of the
position controller Type 8692
22.3.16. SET.FACTORY
resetting to the factory settings
This function allows all settings implemented by the user to be reset to the delivery status.
All EEPROM parameters with the exception of the calibration values are reset to default values. Then a hardware
reset is implemented.
SET.FACTORY
RUN
Press for
approx. 3 s
factory
reset
Figure 72: Operating structure SET.FACTORY
→
To activate the SET.FACTORY function, hold down the selection key on the right (RUN) for approx. 3 s until
the countdown has elapsed.
To adjust the positioner to the operating parameters, re-implement self-parameterisation of the position
controller (
X.TUNE).
english
Type 8692, 8693