Burkert Type 8693 - Manual (Page 138)

138
Start-up and operation of the
position controller Type 8693
-2-
PV-SCALE - 2 - Scaling of the process controller for frequency input signal
type (PV INPUT frequency)
The PV-SCALE function specifies the following settings for frequency input signal type:
• The unit of the process actual value.
• The position of the decimal point.
• The values for the lower and upper process actual value.
• The K-factor.
If the settings for the unit of the process actual value or the position of the decimal point are input or
changed, this setting applies to all scaling values (
PVmin, PVmax, SPmin, SPmax).
+
←
PVmin 0.0
PVmin 0.0 l/s
INPUT
OK
43)
PV SCALE
ENTER
EXIT
+
←
PVmax 100.0
PVmax 100.0 l/s
INPUT
OK
43)
K-Factor
ENTER
EXIT
VALUE 1
TEACH IN
Figure 87: Operating structure P.CONTROL - PV-SCALE - Frequency
43)
If the sub-menu is left by pressing the selection key on the left (ESC), the value remains unchanged.
english
Type 8692, 8693