Burkert Type 8693 - Manual (Page 96)

96
Start-up and operation of the
position controller Type 8692
22.3. auxiliary functions
22.3.1. Overview of auxiliary functions for the position controller
Type 8692
ENTER
CHARACT
EXIT
ADD.FUNCTION
Selection of the transfer characteristic between
input signal and stroke (correction characteristic)
CUTOFF
Sealing function for position controller
DIR.CMD
Effective sense of direction between input signal
and nominal position
DIR.ACT
Assignment of the aeration state of the actuator
chamber to the actual position
SPLTRNG
Signal split range; input signal as % for which the
valve runs through the entire stroke range.
X.LIMIT
Limit of the mechanical stroke range
X.TIME
Limiting the control speed
X.CONTROL
Parameters for the position controller
SECURITY
Code protection for settings
SAFEPOS
Inputting the safety position
SIG.ERROR
Configuration of signal level fault detection
BINARY. IN
Activating of the binary input
OUTPUT
Configuration of the outputs (only with auxiliary board
for analogue feedback signal or binary outputs)
CAL.USER
Calibration
SET.FACTORY
Reset to factory settings
SER. I / O
Configuration of serial interface
EXTRAS
Set colours on display
SERVICE
SIMULATION
For internal use only
In process
Figure 45: Overview - auxiliary functions, position controller Type 8692
english
Type 8692, 8693