Burkert Type 8693 - Manual (Page 150)

150
Start-up and operation of the
position controller Type 8693
24.2. switching between the operating levels
process operating level ► configuration level
Both in the MANUAL and AUTOMATIC operating state you switch to the configuration level by pressing the left
selection key (MENU) for approx. 3 seconds. During these 3 seconds 2 bars converge on the display (Countdown).
At the Configuration level the operating parameters can be input or changed, auxiliary functions supplemented or
the automatic adjustment (
X.TUNE) of the controller started.
A precise description of the individual functions can be found in the chapters entitled "20.4. Specifying
the basic settings" - "22. Configuring the auxiliary functions" and in “25. Auxiliary functions for the process
controller”.
configuration level ► process operating level
Press the left selection key (EXIT) to switch from the Configuration level to the Process operating level. In doing so,
the operating state which was selected before the switchover (AUTOMATIC or MANUAL) is set.
24.3. auTOmaTic operating state
Bar running from left to right along the upper edge of the display.
Normal control mode is implemented and monitored in AUTOMATIC operating state.
24.3.1. meaning of the keys
key
configu-
ration
46)
description
Left selection key MENU Switch to the Configuration level (press for approx. 3 s)
Right selection key MANU Switch between the AUTOMATIC (AUTO) or MANUAL
(MANU) operating modes
Up arrow key SP
POS
CMD
TEMP
PV Switch between the displays
Down arrow key CMD
TEMP
PV
SP
POS
Table 37: Meaning of the keys
46)
Displayed only when P.CONTROL auxiliary function activated
english
Type 8692, 8693