Burkert Type 8693 - Manual (Page 86)

86
Start-up and operation of the
position controller Type 8692
Sequence.for.automatic.adjustment.of.the.position.controller.to.the.particular.operating.conditions
Display Description
X.TUNE
started
TUNE #0
Init
TUNE #1
Max-Pos
TUNE #2
Min-Pos
:
X.TUN
Eready
or
TUNE
err/break
Start of
X.TUNE
Display of the X.TUNE phase which is currently running
(progress is indicated by a progress bar along the upper edge of the display).
Display at the end of X.TUNE
Display when a fault occurs
Table 25: Sequence for X.TUNE
20.5.5. adding auxiliary functions
ADD.FUNCTION
With ADD.FUNCTION auxiliary functions can be included in the main menu.
See chapter entitled "22. Configuration of auxiliary functions".
→
Skip this menu option during the initial start-up.
20.5.6. leaving the main menu
→
To leave the main menu, press the left selection key (EXIT).
In doing so, the changes are transferred to the memory (EEPROM). "save EEPROM" is indicated on the display.
The device is then returned to the operating state in which it was before you switched to the main menu (MANUAL or
AUTOMATIC).
english
Type 8692, 8693