Burkert Type 8693 - Manual (Page 154)

154
Start-up and operation of the
position controller Type 8693
25. auxiliary funcTiOns fOr The prOcess
cOnTrOller
In this chapter only those auxiliary functions are described which differ from the position controller Type 8692.
All other auxiliary functions and their settings can be found in the chapters entitled "23. Configuring the auxiliary
functions".
25.1. Overview of the auxiliary functions
ENTER
CHARACT
EXIT
ADD.FUNCTION
Selection of the transfer characteristic between
input signal and stroke (correction characteristic)
CUTOFF sealing function for position controller
DIR.CMD
Effective sense of direction between input signal and
nominal position
DIR.ACT
Assignment of the aeration state of the drive
chamber to the actual position
SPLTRNG 50)
Signal split range; input signal as % for which the
valve runs through the entire stroke range.
X.LIMIT Limit of the mechanical stroke range
X.TIME Limiting the control speed
X.CONTROL Parameterization of the position controller
SECURITY code protection for settings
SAFEPOS Input the safety position
SIG.ERROR configuration of signal level fault detection
BINARY. IN Activation of the binary input
OUTPUT configuration of the outputs (option only)
CAL.USER calibration
SET.FACTORY Reset to factory settings
SER. I / O Configuration of serial interface
EXTRAS Set colors on display
SERVICE
SIMULATION
For internal use only
Simulation
P.CONTROL parameterization of the pid process controller
Figure 96: Overview - auxiliary functions 8693
50)
SPLTRNG auxiliary function can only be selected if P.CONTROL auxiliary function is inactive.
english
Type 8692, 8693