Configuration.example.2, Configuration example 2 – Burkert Type 8693 User Manual
Page 211
211
DeviceNet
47.
cOnfiguraTiOn example 2
This example describes the principle procedure for setting up the process image of a DeviceNet master/scanner
using the software
RSNetWorx for DeviceNet (Rev. 4.12.00).
Setting up the
scan list and setting the I/O parameters
First of all the
scan list of the DeviceNet master/scanner is set up. To do this, the devices listed in the left part of the
corresponding window are included in the scan list in the right part of the window. Then the I/O parameters can be
changed for each device included in the scan list. This is required if assemblies which differ from the default settings
were selected during configuration of the positioner in question.
“Figure 129: ” indicates the setting of the I/O parameters when
input assembly
POS+CMD+ERR (5 bytes long) is selected and when
output assembly
INP (2 bytes long; Default Assembly - no change required) is selected
Figure 129: Screenshot - DeviceNet - Figure 4
english
Type 8692, 8693