FEC FUSIONE-HS-2 - Manual (Page 105)

FEC Fusion Operations Manual
FIG. 6-1-2b Angle Control Functions for Two
NOTE: When performing multiple step Angle control fastening, the rotation Angle should be
performed as one continuous operation. There should be no intermediate stop
tion points once Snug Torque has been sensed and rotation angle is being controlled.
Under special conditions multiple steps can be performed using intermediate Torque or Angle
stop/synchronization points
FIG. 6-1-2c Angle
Snug Torque
Threshold Torque
Speed Change Torque
1 st Torque
Crossover Torque
Snug Torque
Threshold Torque
Speed Change Torque
Crossover Torque
Operations Manual Chapter 6: Fastening Instructions (Rev.
Page 6-9
2b Angle Control Functions for Two-Step Fastening (1
NOTE: When performing multiple step Angle control fastening, the rotation Angle should be
performed as one continuous operation. There should be no intermediate stop
tion points once Snug Torque has been sensed and rotation angle is being controlled.
Under special conditions multiple steps can be performed using intermediate Torque or Angle
stop/synchronization points as shown below.
2c Angle Control Functions for Two-Step Fastening (1
Snug Torque
Threshold Torque
Speed Change Torque
Torque
Crossover Torque
Final Time 1 st Time
Standard
Angle
Torque
Snug Torque
Threshold Torque
Speed Change Torque
1 st Angle
Crossover Torque
Final Time 1 st Time
Standard
Angle
Torque
Chapter 6: Fastening Instructions (Rev. 2)
(1 st step Torque)
NOTE: When performing multiple step Angle control fastening, the rotation Angle should be
performed as one continuous operation. There should be no intermediate stop / synchroniza-
tion points once Snug Torque has been sensed and rotation angle is being controlled.
Under special conditions multiple steps can be performed using intermediate Torque or Angle
Step Fastening (1 st step Angle)
Angle/Time
Angle/Time