FEC FUSIONE-HS-2 - Manual (Page 149)

FUSION Operations Manual
7.3 Download / Setup Mode Operation (Bypass Mode Only)
The FUSION system has two
“MODE” and “SET” Buttons, on the front of the Controller, simultaneously, or by the PLC B
pass input. The operational modes available in the
der this condition, the “MODE” and “SET” Buttons have been pressed simultaneously, or the
BYPASS external signal is active. During the
lows setting of all available parameter presets.
7.3.1 Download Mode selection
Immediately after the bypass condition has been entered, the unit is in the
Setup mode with the unit number displayed on the Count /D
Console software allows
program the CONTROLLER
change to the primary
communication to an external computer, the download mode will be maintained until the o
eration is completed.)
(Refer to the AFC Console Manual for information about the Download Mode).
FUSION Operations Manual Chapter 7: System Operations (Rev.2)
Page 7-25
7.3 Download / Setup Mode Operation (Bypass Mode Only)
The FUSION system has two operational states that are controlled by depressing the
“MODE” and “SET” Buttons, on the front of the Controller, simultaneously, or by the PLC B
pass input. The operational modes available in the Bypass State are identified below. U
, the “MODE” and “SET” Buttons have been pressed simultaneously, or the
BYPASS external signal is active. During the Bypass State, the controller
lows setting of all available parameter presets.
Download Mode selection
er the bypass condition has been entered, the unit is in the
with the unit number displayed on the Count /D-No Display
software allows the CONTROLLER Unit setup via a computer
CONTROLLER unit with the display programmer, press the [MODE] key to
primary setup mode. (If the CONTROLLER unit is performing some data
communication to an external computer, the download mode will be maintained until the o
mpleted.)
Console Manual for information about the Download Mode).
Pressing both the [MODE] & [SET] keys at the same time
puts the controller into BYPASS mode.
FIG. 7-3-1 CONTROLLER Unit in Download mode.
7: System Operations (Rev.2)
operational states that are controlled by depressing the
“MODE” and “SET” Buttons, on the front of the Controller, simultaneously, or by the PLC By-
are identified below. Un-
, the “MODE” and “SET” Buttons have been pressed simultaneously, or the
controller displays and al-
er the bypass condition has been entered, the unit is in the initial Download /
No Display. The AFC User
Unit setup via a computer’s RS232 Port. To
unit with the display programmer, press the [MODE] key to
unit is performing some data
communication to an external computer, the download mode will be maintained until the op-
Console Manual for information about the Download Mode).
Pressing both the [MODE] & [SET] keys at the same time
puts the controller into BYPASS mode.
1 CONTROLLER Unit in Download mode.