FEC FUSIONE-HS-2 - Manual (Page 36)

Chapter 3: System Description
Page 3-6
BACK PANEL CONNECTOR FEATURES
ITEM ITEM AS MARKED ON UNIT DESCRIPTION
1 CN1
Twist Lock single connector for tool cable connection. Twist
lock type connector can be connected and disconnected by
twisting the outside ring 90 degrees Clockwise and Counter
Clockwise respectively
2 RS232C
DB9 connector for fastening result data Output only. Utilized for
connection to a PLC, printer, personal computer, etc.
3 AC100 ~ 230 VAC
Primary power-supply input connection.
Input for 100 ~ 230 VAC single-phase 50/60Hz. +/- 10%
AUTO SWITCHING
*DO NOT RUN WITHOUT GROUND CONNECTED!
4 TB1
Connection point for discrete inputs and outputs (I/O). When
wired in, the entire connector can be removed by loosening the
upper and lower retaining screws. Refer to chapter 4 for
detailed descriptions of I/O signal.
.
5 Ground Lug
Ground terminal for connection to the Back Panel Cover’s
ground wire
6 RTC Connection 8 pin plastic connector – Real Time Clock Connection
7 SYNC Connection 4 pin plastic connector – Sync. Connector
8 Interface option Mtg. Interface adapter port – Optional Fieldbus or Ethernet board
9 Breaker
Electrical Leakage Breaker / Ground Fault detector. I=on,
0=off
WARNING!: DO NOT RUN THIS SYSTEM WITHOUT A PROPER GROUND CONNECTED
TO THE CONTROLLER. THE CONTROLLER IS SUPPLIED WITH A 3-PRONG AC
CABLE INCLUDING A GROUND CONDUCTOR. DO NOT BYPASS THE GROUND
CONNECTION OR SEVERE INJURY OR SHOCK MAY RESULT!