FEC FUSIONE-HS-2 - Manual (Page 77)

FEC FUSION Operations Manual Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-39
PROFIBUS
CONNECTOR
TERMINATION
SWITCH
ADDRESS
SETTING
LED
INDICATORS
4.15.1 Fieldbus Interfaces – Profibus-DP
The Profibus-DP communication interface allows slave connection to an industrial Profibus-
DP network. Profibus-DP allows industrial devices to be controlled over an open network ar-
chitecture enabling device connection at various locations in the field. This “Fieldbus” tech-
nology reduces hardwiring/cabling & provides ease of installation. It can interface to many
devices such as limit switches, sensors, directional valves, motor starters, bar code readers,
process sensors, frequency drives, etc. The network can have up to 126 nodes. Its maxi-
mum communication baud rate is 12M baud and its minimum baud rate is 9.6K baud.
Node addressing is selectable using the address selection switch. Baud rate is auto detected
from the master and no user setup is required. Module & Network status LED’s provide net-
work diagnostics.
Maximum I/O data is pre-configured for the FUSION system. FEC uses 16 Bytes (128bits)
for Fusion OUTPUTS (Fusion to PLC) which includes Binary Integer output of both Fastening
Torque & Angle. Fusion INPUTS (PLC to Fusion) uses 4 Bytes (32 bits). The I/O signal map
defines what signals/data for each address. (See below)
Note: The Profibus-DP interface is implemented according to the Profibus-DP EN 50 170
(DIN 19245 Part 1) specification.
FEC integrates the Profibus-DP board manufactured by HMS Fieldbus Systems AB into the
Fusion modular I/O board. For further technical information on the Profibus-DP interface go
to the HMS website. (www.hms.se)
Further Profibus information can be found on the Profibus website at www.profibus..com .
Profibus Interface Board