FEC FUSIONE-HS-2 - Manual (Page 131)

FUSION Operations Manual Chapter 7: System Operations (Rev.2)
Page 7-7
7.2.3 Fastening Results Display Mode.
In Fastening results display mode (when [COUNT/D-NO] shows _0 ~
≡≡≡≡6666
), data can be ob-
tained by pressing the [ ↓↓↓↓ ] and [ ↑↑↑↑ ] keys to scroll the [COUNT/D-NO] until the desired DATA
item is displayed. The following information will be displayed in the [DATA] display section
for the displayed [D-NO]:
D-No DATA
_0 PEAK TORQUE.
_1 FINAL ANGLE
_2 1ST TORQUE RATE
_3 2ND TORQUE RATE.
_4 1ST STEP TIME.
_5 FINAL STEP TIME.
_6 CYCLE TIME
_7 FASTENING MODE.
_8 3RD TORQUE RATE
_9 NOT USED
====0 FASTENING MODE.
=1 FASTENING STEPS
=2 NOT USED
=3 SELF CHECK (ON: enabled, OFF: disabled)
=4 REVERSE FLAG (ON:Reversed, OFF: Not Reversed
=5
CAUSE OF FASTENING STOP:
0: RESET / NO DATA / AFTER REVERSE.
1: ABNORMAL SIGNAL.
2: BYPASS SIGNAL.
3: STOP SIGNAL.
4: REJECT.
5: ACCEPT.
=6 TORQUE JUDGE tq H/L (FINAL) H/L (PEAK)
=7 ANGLE JUDGE AN H/L
=8 RATE JUDGE r H/L (1ST) H/L (2ND) H/L (3RD)
=9 TIME JUDGE ti H/L (1ST) H/L (FINAL)
≡≡≡≡0 1ST INCREMENT TORQUE.
≡≡≡≡1 2ND INCREMENT TORQUE.
≡≡≡≡2 1ST FINAL TORQUE
≡≡≡≡3 1ST PEAK TORQUE.
≡≡≡≡4 FINAL TORQUE.
≡≡≡≡5 ANGLE AT PEAK TORQUE
≡≡≡≡6 PEAK CURRENT
FIG. 7-2-3 Fastening results display selection