FEC FUSIONE-HS-2 - Manual (Page 138)

Chapter 7: System Operations
Page 7-14
8) Fastening Mode and Fastening Steps [WORK]-1~16, [D-No]-00.
The fastening mode is entered into [WORK]-1~16, [D-No]-00. Enter the Set Value number
which corresponds to the fastening method desired. The figure below describes the code for
the four numbers and how they relate to the type of fastening method and steps preferred.
Zero’s will display as blank (off) digits if there is no number (1,2 or 3) preceding them. (Ex-
ample: 0020 will display as _ _ 20 or 0121 will display as _121) When entering a new fasten-
ing method, all four digits should be entered and SET.
[ Fastening Method ]
0 = Torque Control
1 = Angle Control
[ Fastening Steps ]
0 or BLANK = 1 Step w/ continuous snug Tq. angle count start*
1 = 1 Step Fastening
2 = 2 Step Fastening – Stops at 1 st Tq.
3 = 3 Step Fastening – Stops at 1 st and CROS Tq.
[ Fastening Direction ]
0 or BLANK = CW (clockwise) Fastening
1 = CCW (counterclockwise) Fastening
[ Reverse Operation ]
0 or BLANK = Not Used
1 = Slow Reverse Start (1.5 sec. @ 20 RPM)
2 = Varispeed
3 = Both 1 & 2
*Normal Snug angle count vs. Continuous Snug Tq. Angle Count
Angle count with normal SNUG mode (XX11)
Angle value is not counted up when torque is below SNUG TORQUE.
[In case Standard Angle is 90 °]
¢¡ °
£
¡ °
¤¢¥§¦©¨¢
Angle count using continuous SNUG TQ angle count Method (XX01)
Once SNUG TORQUE is reached, angle value is counted up regardless of the torque value.
[In case Standard Angle is 90 °]

¡ °
¤¢¥§¦©¨