FEC FUSIONE-HS-2 User Manual
Page 65
FEC FUSION Operations Manual
4.10 Controller Unit DIP Switch
In a multiple controller u
zational purposes. The number is set using the DIP switch located
on the back panel of the unit.
DIP switch located on printed
circuit board through access
panel at the back of unit.
4.10.1 Controller Unit DIP Switch positions 1 ~ 3
•
DIP switch positions 1 ~ 3 are used for setting the special configuration features as defined in the
following explanation. The DEFAULT setting is switch 1
•
DIP Switch 1 -
Zero Check
o
ON – Expanded Zero
o
OFF – Normal Zero
•
DIP Switch 2 -
NOT USED
o
ON – Not Used
o
OFF – Not Used
•
DIP Switch 3 -
Disable Motor Ramp Down
o
ON - Enables dynamic brake for motor speed changes.
- Used for applications which overshoot standard torque
- Will reduce Motor/Tool life
o
OFF - Disables Dynamic brake during speed changes (Default)
Note: The Controller unit must be powered off and on
initialized.
FEC FUSION Operations Manual
Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-27
Unit DIP Switch Setting.
controller unit system, it may be beneficial to address the controllers
purposes. The number is set using the DIP switch located behind the access panel
of the unit.
DIP switch located on printed
ircuit board through access
anel at the back of unit.
FIG. 4-10 Dip Switch settings
Unit DIP Switch positions 1 ~ 3
DIP switch positions 1 ~ 3 are used for setting the special configuration features as defined in the
. The DEFAULT setting is switch 1 – 3 OFF.
Check acceptance window selection
.
Zero Check acceptance window
Zero Check acceptance window
NOT USED
Disable Motor Ramp Down
.
Enables dynamic brake for motor speed changes.
Used for applications which overshoot standard torque
Will reduce Motor/Tool life
Disables Dynamic brake during speed changes (Default)
unit must be powered off and on again for the DIP switch changes to be
Chapter 4: System Setup and Wiring (Rev. 2.1)
controllers for organi-
behind the access panel
DIP switch positions 1 ~ 3 are used for setting the special configuration features as defined in the
again for the DIP switch changes to be