FEC FUSIONE-HS-2 - Manual (Page 183)

FUSION Operations Manual Chapter 9: Troubleshooting (Rev. 2)
Page 9-15
9.11 FUSION CONTROLLER Unit Fastening Faults and Causes
9.11.1 Torque Accept Conditions
The Accept LED will light for the following reasons:
1. The previous fastening was completed within all preset limits (TORQUE, ANGLE, 1st RATE, 2nd
RATE, and TIME).
9.11.2 Torque Reject Conditions
The Reject LED will light for the following reasons:
1. The final fastening torque is not between the low and high Torque limits, low and high angle limits,
low and high rate 1, 2 and 3 or the time 1 or final time limits set in the parameter presets.