FEC FUSIONE-HS-2 - Manual (Page 57)

FEC FUSION Operations Manual
4.8.2 Rear Panel DB9
Connector: DB-9P (Male)
Mating Connector: DB
PIN
1
2
3
4
5
6
7
8
9
Note: The CTS signal needs to be activated in order for the fastening data to be output. If it
the data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be
connected to the RTS signal if data is to be “dumped” at every fastening.
Connection with hardware handshake (
Connection without handshake
¢¡¤£ £ ¥§¦¢¨
©
  ©
!" ©
# ¤
$&% ©
')(10 2§3)4¢5
6879@A
B)C 6
D"C 6
D&B¤9
E B19
F"G 6
FEC FUSION Operations Manual Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-19
DB9 RS232 PC Connection (Fastening Data Output)
9P (Male)
Mating Connector: DB-9S (Female)
SIGNAL DESCRIPTION
NOT USED
RXD NOT USED
TXD TRANSMIT DATA
DTR DATA TERMINAL READY (ALWAYS ON)
GND SIGNAL GROUND
DSR NOT USED
RTS REQUEST TO SEND (ALWAYS ON)
CTS CLEAR TO SEND
NOT USED
The CTS signal needs to be activated in order for the fastening data to be output. If it
the data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be
connected to the RTS signal if data is to be “dumped” at every fastening.
Connection with hardware handshake (with DTR signal)
Connection without handshake – data “dumped” (without DTR signal)
¨¢HPIRQS¨)¡¢TVU PWXTVY
 ` Qa£ ¡ ©Scbad Qa£ ¡
e e !" ©
f
g fih © !
p q $&% ©
5PrtsS4 (Puwv 'PxXuwy
A € s0 ( 6"7‚9@ƒA „† s0 (
‡ ‡ D"C 6
ˆ
‰
 ˆi‘ 68B D
’ ‰ F&G 6
Chapter 4: System Setup and Wiring (Rev. 2.1)
Fastening Data Output)
TERMINAL READY (ALWAYS ON)
The CTS signal needs to be activated in order for the fastening data to be output. If it
the data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be
connected to the RTS signal if data is to be “dumped” at every fastening.