FEC FUSIONE-HS-2 - Manual (Page 140)

Chapter 7: System Operations
Page 7-16
Data No.14 Speed Change Torque [Nm, Kgm...]
Setting range: 0 ~ [10: Calibration torque] × 1.0
Set the torque value that switches slow down speed to torque speed.
Data No.15 1ST Torque [Nm, Kgm...] Setting range: 0 ~ [10: Calibration torque] × 1.0
Data No.23 1ST Angle [deg] Setting range: 0 ~ 9999
1 ST stop / synchronization point for multiple step fastening operations.
End point for 1 st torque rate calculation. [17: Threshold Torque is beginning]
Shift point for changing to Torque Speed [53: Torque Speed]
End of 1 st Time and beginning of Final Time
Even if Freerun Revolutions are not achieved, the speed will change to
Slow Down Speed when Speed Change Torque is detected.
SPEED
60 Freerun Revolutions
51 Freerun
Speed
40 Initial Time
14 Speed Change Torque
52 Slowdown Speed
53 Torque Speed
54 Reverse Speed
50 Initial Speed
63 Reverse Revolutions
Fastening