FEC FUSIONE-HS-2 User Manual
Page 55
Advertising
FEC FUSION Operations Manual
Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-17
4.7.5 PLC Wiring Sample
This diagram represents standard I/O connections to a PLC. The 24VDC power can be sup-
plied from the FUSION controller (terminals A10,B10) if total consumption is less than 0.5A.
FIG. 4-7-5 PLC Wiring Sample
All inputs and outputs (I/O) are active true low. All interface devices must accommodate ac-
tive true low logic for correct operation. Outputs are rated at +12~24 VDC, 40mA. When ac-
tivated, open collector sink outputs (normally high) pull the input device signal low (0 VDC).
Inputs are sourced (normally high) and activated when pulled low (0 VDC).
Advertising