FEC FUSIONE-HS-2 - Manual (Page 74)

Chapter 4: System Setup and Wiring
Page 4-36
4.14.1 Ethernet Set-up of PC to Communicate to Ethernet Module
The PC used to configure the Ethernet module must have the Ethernet TCP/IP settings con-
figured for the following to communicate to the Fusion Ethernet module.
(See you network administrator or Windows® support for detailed information to set-up your
Ethernet port if you are unfamiliar with Ethernet port set-up. You may also request the “Fu-
sion Ethernet Module Set-Up Procedure” from FEC for more detail)
PC Ethernet Set-up
IP address: 10.1.1.1
Subnet mask: 255.255.255.0
Default Gateway: 10.1.1.1
Once the PC is configured and connected to the Ethernet Module using an Ethernet cross-
over cable, you can use your web browser (Ex. Internet Explorer) to configure the Ethernet
module including the network IP address , Station Name, etc.
Open the web browser and put this address in the address bar ;
This screen should appear:
If this screen does not appear, re-check your cables and connection. (See the “Fusion Ethernet
Module Set-Up Procedure” from FEC for more detail)
Note: If this screen does not show up, the IP address setup of the Fusion Ethernet module
may have already been changed. The IP configuration setup of the Fusion Ethernet Module
can be reset to default by putting a jumper wire between pin 3 and 5 of the Fusion Ethernet I/O
“Power & I/O” connector at power up.
Once the Ethernet module is configured for the network you are connecting to, you can disconnect
the PC and cycle power. Upon the next power-up, the Ethernet module can be connected to the con-
figured network using the IP address that was configured.