FEC FUSIONE-HS-2 - Manual (Page 156)

Chapter 7: System Operations
Page 7-32
7.5 Optional Real Time Clock Module
The Fusion system stores 10000 cycles of fastening results in its flash memory. In order to
add a Date/Time stamp to this data, an optional Real Time Clock module can be added to the
controller. This module is added into the back of the controller inside of the access panel at
the upper right side.
When this clock module is added, the date & time will be attached to the stored data every
cycle. This function is available in Firmware version 2.20 or later
The AFC software will be required for restoring stored data from controller.
Clock module model : ANG-RTC
Backup power source : Electric double layer capacitor
Backup memory duration : Approx. 10000 hours
Backup power charge time Approx. 1hour
If the controller power is turned off for more than 2 months, the clock backup power will be
lost & the time settings will be lost.
The Clock can be set using the front display & keypad the same method as changing para-
meter data. See the table below for parameter numbers.
Work # Data # Item Example
00 30 Year ‘yyyy’ ‘2005’ Year 2005
00 31 Month & Date ‘mmdd’ ‘0131’ January 31st
00 32 Hour & Minute ‘hhmm’ ‘1759’ 17:59
00 33 Seconds ‘00ss’ ‘0020’ 20 second
Seconds will be set as ‘00’ when Hour & Time (Data # 32) is changed.
Note: Clock may be off approx. 10 seconds / month. Adjust as required.