FEC FUSIONE-HS-2 - Manual (Page 148)

Chapter 7: System Operations
7.2.6 STATUS display
Two types of controller STATUS can be displayed, either STOP or ABNORMAL.
1) When the STOP signal is activated:
The [DATA] display will indicate when the STOP signal has
the figure.
2) When an ABNORMAL condition occurs
lowed by a number that represents the Abnormal number code. The
a dash and a number that represen
The figure below shows a display reporting the Abnormal code 9 and the Sub code number 0.
(Refer to chapter 9)
Page 7-24
STATUS can be displayed, either STOP or ABNORMAL.
1) When the STOP signal is activated:
display will indicate when the STOP signal has halted the FUSION as shown in
2) When an ABNORMAL condition occurs, the display will show a flashing "A" character fo
lowed by a number that represents the Abnormal number code. The [COUNT/D-NO]
a dash and a number that represents the SERVICE CODE NUMBER or SUB Code.
The figure below shows a display reporting the Abnormal code 9 and the Sub code number 0.
as shown in
the display will show a flashing "A" character fol-
NO] displays
ts the SERVICE CODE NUMBER or SUB Code.
The figure below shows a display reporting the Abnormal code 9 and the Sub code number 0.