FEC FUSIONE-HS-2 - Manual (Page 26)

Chapter 2: Specifications
Page 2-4
2.3 Controller Unit Specifications
Controller Model HFC-EC-16
Motor Model RM80, RM50
Controller Supply Voltage Single Phase 100~ 230 VAC 50/60/Hz +/- 10%
Power Consumption (Running) 95 watt/hour @ 99% Capacity / 50% Duty
Power Consumption (Idle) 37 watt/Hour
Inrush current @ Power on 11A
If the equipment is powered on and off repeatedly, internal circuit protection devices
may trip due to high in-rush current overload, and the Controller will not function until
it is cleared (powered off). (It may take up to five minutes of “off” time to clear the self-
protection circuit.)
• Controller Processor: 32-bit RISC (Reduced Instruction Set CPU)
• Parameter / Firmware Storage: Flash ROM
• Fastening Data Storage: More than 10,000 cycles (stored in flash)
• Fastening Method: Torque and Angle, 1 ~ 3 step fastening
• Torque Rate Calculation: 3 ranges
• Data communications:
(1) RS232 – Front Panel - Input/output – Programming and Data collection
(1) RS232 – Rear Panel – Output – Printer or data collection device.
(1) T/A MON – Front Panel – Output – analog Torque and Angle analysis.
(1) Discrete I/O – Rear panel - Control and PLC interface
(1) Real Time Clock Connection
(1) Optional Ethernet – Output - Data collection
(1) Optional Fieldbus – Input/Output – Control and PLC interface
Caution