Running the self test, Running the self test -57 – HID DTC400E/C30E/M30E User Guide User Manual
Page 104
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
4-57
Running the Self Test
Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has
been conducted or (c) a part has been replaced to check for proper Printer operation.
Step Procedure
1
Verify that a full-color or Premium Resin Ribbon Cartridge is installed and that
cards are properly loaded.
Caution: If the power is ON, disconnect the Power Cable from the
Printer’s rear panel.
2
Press and hold the Pause/Resume button.
3
While holding down the Pause/Resume button, plug the power cable back into
the Printer.
4
• Full Color Ribbon Cartridge installed: The Printer will print a 3-color
process gray scale on the front of the card. The overlay pass is not printed
during the Self-test. (See Display A & B below)
• Premium Resin Ribbon Cartridge installed: The Printer will print a
single color gray scale on the front of the card.