HID DTC400E/C30E/M30E User Guide - Manual (Page 111)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 5-5
Reviewing the Telnet Command Table
The following table describes available Telnet commands. (Note: You can enter partial full-
word commands: the Printer will respond with additional help. For example, you can enter
list, and the Printer will respond with all subcommands to the list command.)
Telnet Command Command Purpose Command Format
?
help
Display help for Telnet
commands. ?
reset
Reset the Ethernet interface for
the Printer/Encoder.
reset
ping
Send a ping command to another
IP address as a test of the
Ethernet interface. ping <IPADDR>
all Display all information about this
Printer. list all
diff Display all differences between
current and stored network
settings. list diff
uptime Display how long since the
interface was last reset. list uptime
sysinfo Display information about the
Printer (i.e., model, label, contact,
location, Firmware version and
date, and serial number). list sysinfo
ribbon Display information about the
installed Ribbon in the Printer. list ribbon
net Display information about the
current network settings of the
Ethernet interface. list net
stored net Display information about the
stored network settings of the
Ethernet interface. list stored net
list
default net Display information about the
default network settings of the
Ethernet interface. list default net