HID DTC400E/C30E/M30E User Guide - Manual (Page 114)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 5-8
Telnet Command Command Purpose Command Format
from Restore the network settings
from either the default
settings or the current
settings. store net from
default|current
mode Specify the Ethernet
interface mode as:
automatic, full or half duplex;
10 or 100 mHz. store ifc mode
auto|10half|10full|100half|1
00full ifc
from Set the Ethernet mode
settings from the default or
current settings. store ifc from
default|current
save Save all current settings as
the stored settings in the
permanent memory. save
load Take the settings from the
stored memory and make
them the current settings. load
lpstat Display information about
the Printer status.
This includes the status and
device response.
See the Printer web page
description.
lpstat
cancel Cancel a specific print job
from the print queue. cancel 10
quit Stop the current Telnet
session. quit