HID DTC400E/C30E/M30E User Guide User Manual
Page 271
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
11-3
Access)
that are used for dedicated high-speed communication between the
PC and the Printer port.
Centronics
A parallel communications interface that has become the standard
for connections to Printers, designed by the Centronics Corp.
Coercivity
The property of a Magnetic Stripe that indicates the amount of force
needed before magnetic saturation, measured in Oersted (Oe).
Color matching
The process of adjusting color hue, saturation and brightness, to
duplicate a desired color. An algorithm within the Driver, which
adjusts the color balance and provides output with the desired
color, automates this process.
Compressed air
Air stored in a tank or produced by an aerosol can, delivered by
through nozzle at a high speed. Used in the Printer to blow out
debris.
Contrast
The degree of difference in luminance of two areas.
Control panel
The panel on the Printer from which the user can control Printer
functions. The Printer is usually composed of the control buttons
and an LED or LCD display.
CR-79
A card dimension standard of 2.0625" L X 3.3125" W (+/-0.002" W,
+/-0.005" L) or 52.400 X 84.150 mm.
CR-80
A card dimension standard of 2.125" X 3.370" (+/-0.002" W, +/-
0.005" L) or 53.975 X 85.598 mm.
CR-90
A card dimension standard of 2.375" X 3.625" (+/-0.002" W, +/-
0.005" L) or 60.325 X 92.075 mm.
CR-100
A card dimension standard of 2.625" X 3.875" (+/-0.002" W, +/-
0.005" L) or 66.675 X 98.425 mm.
Cursor
The marker in the LCD Display Window that indicates the active
selection.
Darkness
A reference to color saturation.
DB-9
A 9 pin, D-shaped connector, typically used in serial port interfaces.
DC Motor
A Motor that works on DC with continuous motion.
DC (Direct Current)
Electronic flow that is unidirectional, flowing from the positive (+) to
negative (-) of a power source.
Default
A setting or parameter that comes preset from the factory in Driver
or firmware. Performance parameters may be customized in the
Driver, but can be reset to the factory values usually through the